Crank Handle - Jet JMD-18 Operator's Manual

Motor Mount Lock Lever (A, Fig. 9) - located on the
right side of the head casting. Locks and unlocks the
motor mounting plate. Loosen to tension v-belts and
then tighten.
Head Pivot Lock (8, Fig. 9) - located on the right
rear of the head casting. Loosen two hex nuts to
rotate the head 360°. Tighten two hex nuts to lock
the head.
On-Off Switch (A, Fig. 10) -located on the front of
the head casting. Turns power on and off to the
mill/drill.
Quill Lock Handle (8, Fig. 10) - located on the front
left of the head casting. Turn clockwise to lock the
quill in the desired position. Turn counter-clockwise
to release.
Head Elevating Crank Handle (A, Fig. 11) - located
at left rear of head casting. Loosen head pivot lock
nuts (8, Fig. 8) and turn handle clockwise to raise
head on the column and counter-clockwise to lower
head.
Fig. 9
Fig. 10
Fig. 11
8