Removal and Replacement Procedures— Ultra-Slim Desktop (USDT) Chassis
8.11 Front I/O Device
1. Prepare the computer for disassembly
2. Remove the computer top access panel
3. Remove the system fan
4. Remove the front chassis panel
✎
Removing the front chassis panel makes it easier to access the cable connectors on the system
board.
5. Disconnect the I/O device cables from the system board.
6. Remove the screw that secures the I/O device to the front chassis panel 1, then lift the
device up and off the panel 2 being careful not to snag the cables as you pull them through
the opening.
To install the front I/O device, reverse the removal procedure.
8–16
(Section 8.1, "Preparation for
(Section 8.3.1, "Top Access
(Section 8.9, "System
Fan").
(Section 8.10, "Front Chassis
336492-005
Disassembly").
Panel").
Panel").
Service Reference Guide