Drive Cage Assembly - HP Evo D500 Reference Manual

8.16 Drive Cage Assembly

1. Prepare the computer for disassembly
2. Remove the computer top access panel
3. Remove the hard drive
4. Remove the system fan
5. Remove the front chassis panel
6. Disconnect the power switch cable from the system board
Assembly").
7. Disconnect the front I/O cable from the system board
8. Remove the power supply
9. Remove the two screws that secure the drive cage to the chassis 1.
10. Pull up evenly on the drive cage 2 to disengage the MultiBay connector card from the
system board and to release the cage from the chassis.
To install the drive cage, reverse the removal procedures.
✎
Make sure the eject lever is in its rear-most position before installing the drive cage. Test the
action of the eject lever before installing the retaining screws.
Make sure that the 9 mm long screw is used to secure the foot of the drive cage thru the system
board.
Service Reference Guide
Removal and Replacement Procedures— Ultra-Slim Desktop (USDT) Chassis
(Section 8.1, "Preparation for
(Section 8.3.1, "Top Access
(Section 8.8.1, "Hard Drive").
(Section 8.9, "System Fan").
(Section 8.10, "Front Chassis
(Section 8.14, "Power
336492-005
Disassembly").
Panel").
Panel").
(Section 8.12, "Power Switch
(Section 8.11, "Front I/O
Supply").
Device").
8–23