Power Switch Assembly - HP Evo D500 Reference Manual

7.12 Power Switch Assembly

1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Disconnect the power switch/LED cable from the system board.
4. Carefully cut the cable tie that secures the power switch cable to the power supply cable
cable bundle.
Ä
CAUTION: Be careful when cutting the cable tie not to cut any cables.
5. Squeeze the switch holder retaining clips together at the front of the chassis 1 and push the
switch assembly out of the chassis 2.
To install the power switch assembly, reverse the removal procedure.
Service Reference Guide, d500
Removal and Replacement Procedures— Small Form Factor (SFF) Chassis
(Section 7.1, "Preparation for
(Section 7.5, "Computer Access
336492-005
Disassembly").
Panel").
7–25