THORLABS TIM101 User Manual page 39

LLGetStatusBits
MoveAbsoluteStepsEx
MoveJog
MoveRelativeStepsEx
MoveVelocity
SaveParamSet
SetButtonParams
SetDriveOPParams
SetJogMode
SetJogOPParams
SetJogStepSize
SetPositionSteps
SetPotParams
ShowEventDialog
StartCtrl
Stop
StopCtrl
Properties
APTHelp
HWSerialNum
Gets the controller status bits encoded in 32 bit
integer.
Initiates an Absolute move.
Initiates a jog move.
Initiates a relative move.
Initiates a move at constant velocity with no end
point.
Saves settings for a specific controller.
Sets the operation mode of the front panel buttons
Sets various drive parameters which define the
speed and acceleration of moves.
Sets the jogging button operating modes.
Sets various drive parameters which define the
speed and acceleration of jog moves.
Sets the jogging step size.
Sets the position counter value.
Sets the speed of a move initiated by the
potentiometer on the top panel of the hardware unit.
Shows the event dialog when it has previously been
disabled using the EnableEventDlg method
Starts the ActiveX Control (starts communication
with controller)
Stops the motor.
Stops the ActiveX Control (stops communication
with controller)
Specifies the help file that will be accessed when the
user presses the F1 key. If APTHelp is set to 'True',
the main server helpfile will be launched.
Specifies the serial number of the hardware unit to
be associated with an ActiveX control instance.
TIM101 Piezo Motor Controller
39