Juniper Day One+ LWC Manual page 5

8. Check that the mounting brackets on each side of the rack are level.
Power On
1. Attach a grounding cable to earth ground and then attach it to the Lightweight Collector's (LWC's) grounding
points.
2. Turn off the power switch on the LWC rear panel.
3. On the rear panel, insert the L-shaped ends of the power cord retainer clip into the holes in the bracket on the
power socket. The power cord retainer clip extends out of the chassis by 3 inches.
4. Insert the power cord coupler firmly into the power socket.
5. Push the power cord into the slot in the adjustment nut of the power cord retainer clip. Turn the nut until it is tight
against the base of the coupler and the slot in the nut is turned 90° from the top of the device.
6. If the AC power source outlet has a power switch, turn it off.
7. Plug in the AC power cord to the AC power source outlet.
8. Turn on the power switch on the LWC's rear panel.
9. If the AC power source outlet has a power switch, turn it on.
10. Verify that the power LED on the LWC front panel is green.
Connect the Lightweight Collector to the Networks
The Lightweight Collector (LWC) uses an internal network port to access the Juniper devices on your network, and an
external network port to access Juniper Cloud.
Here's how to connect the LWC to the internal and external network:
1. Connect the internal network to the 1/10-Gigabit SFP+ port 0 on the LWC. The interface name is xe-0/0/12.
2. Connect the external network to the 1/10-Gigabit SFP+ port 1 on the LWC. The interface name is xe-0/0/13.
5