Juniper Day One+ LWC Manual page 4

Mount a Lightweight Collector on Two Posts in a Rack
You can mount a Lightweight Collector (LWC) on two posts of a 19-in. rack (either a two-post or a four-post rack).
Here's how to mount the LWC on two posts in a rack:
1. Place the rack in its permanent location, allowing adequate clearance for airflow and maintenance, and secure it to
the building structure.
2. Remove the device from the shipping carton.
3. Read General Safety Guidelines and
4. Attach the ESD grounding strap to your bare wrist and to a site ESD point.
5. Secure the mounting brackets to the sides of the LWC using eight screws and the screwdriver. You'll notice there are
three locations on the side panel where you can attach the mounting brackets: front, center, and rear. Attach the
mounting brackets to the location that best suits where you want the LWC to sit in the rack.
6. Lift the LWC and position it in the rack. Line up the bottom hole in each mounting bracket with a hole in each rack
rail, making sure the LWC is level.
7. While you're holding the LWC in place, have a second person insert and tighten the rack mount screws to secure the
mounting brackets to the rack rails. Make sure they tighten the screws in the two bottom holes first and then tighten
the screws in the two top holes.
Warnings.
4