Onboard Devices - Juniper Day One+ LWC Manual

View the Lightweight Collector Connection Status
IN THIS SECTION
View the Connection Status on Juniper Support Portal | 14
View the Connection Status on the Captive Portal | 14
You can view the Lightweight Collector (LWC) connection status on the following portals:
• Juniper Support Portal
• The LWC captive portal. The captive portal provides a more detailed view, and has options that let you change the
LWC configuration settings and perform troubleshooting.
View the Connection Status on Juniper Support Portal
Here's how to view the LWC connection status on Juniper Support Portal:
1. On Juniper Support Portal, click Insights > Collector.
2. Check the summary table to see the Connection Status of the LWC. The status should be shown as Connected.
If the status is shown as Disconnected, check if the LWC is installed and the two ports are cabled correctly. Ensure
that the LWC fulfills the Internal and External Network Requirements as specified in the
Guide. In particular, ensure that the LWC meets the Outbound Connectivity Requirements.
View the Connection Status on the Captive Portal
See "Configure the Lightweight Collector" on page 6

Onboard Devices

You'll need to onboard devices to initiate a periodic (daily) data transfer from the devices to the Juniper Cloud. Here's
how to onboard devices in a JSI setup that uses an LWC:
NOTE: You must be an admin user to onboard a device.
NOTE: Ensure that the NETCONF SSH subsystem is configured on your Juniper devices (on port 22) to onboard
these devices to JSI. JSI supports NETCONF SSH sessions on port 22 only. JSI NETCONF sessions on other
ports, such as port 830, are currently not supported.
for more information.
LWC Platform Hardware
14