Placing Originals In The Auto Document Feeder - Ricoh DSc332 Operating Instructions Manual

Placing Originals in the Auto
Document Feeder
Settings should be made accordingly
in the following situations:
❖ ❖ ❖ ❖ When placing originals consisting of
more than 80 pages:
p.15 "Batch"
❖ ❖ ❖ ❖ When placing originals one by one:
p.16 "SADF"
❖ ❖ ❖ ❖ When placing originals of the same
width but different sizes:
p.17 "Placing originals of mixed
sizes"
❖ ❖ ❖ ❖ When placing custom size originals:
p.17 "Placing custom size origi-
nals"
Note
❒ Do not stack originals above the
limit mark on the side guide of the
ADF.
❒ The last page should be on the bot-
tom.
❒ Do not place objects on the sensors
or cover them with your hands, or
the original size may not be detect-
ed properly. Also, do not place an-
ything on the exposure glass cover
as this could cause a malfunction.
1.
Sensors
A A A A
Set the document guide to the
original size.
B B B B
Place the aligned originals face
up into the ADF.
1.
Limit mark
2.
Document guide
Note
❒ Straighten any curls in the orig-
inals before placing them in the
ADF.
❒ To prevent multiple sheets from
being fed at once, fan the origi-
nals before placing them in the
ADF.
❒ Place the originals squarely.
Batch
The Batch mode enables you to copy
originals of more than 80 pages as a
single document, even if you place
the originals into the ADF in instal-
ments.
Important
❒ Place special originals, such as
translucent paper, one by one.
Placing Originals
1
15