System Settings (Parallel Connection) - Ricoh DSc332 Operating Instructions Manual

Appendix

System Settings (Parallel Connection)

Interface Settings/Parallel Interface
❖ ❖ ❖ ❖ Parallel Timing
Specifies the timing for the parallel
interface. Normally, you do not
need to change this setting.
• ACK inside
• ACK outside
• STB down
Note
❒ Default: ACK inside
❖ ❖ ❖ ❖ Parallel Communication Speed
Specifies the communication
speed of the parallel interface. If
the speed is too high, data may not
be transferred smoothly. If this
6
happens, change the setting to
"Standard".
• High speed
• Standard
Note
❒ Default: High speed
❖ ❖ ❖ ❖ Selection Signal Status
Specifies the signal level of the par-
allel interface.
• High
• Low
Note
❒ Default: High
❖ ❖ ❖ ❖ Input Prime
Specifies whether the prime signal
is active or inactive when an input
prime signal is sent. Normally, you
do not need to change this setting.
• Effective
• Invalid
Note
❒ Default: Invalid
70
❖ ❖ ❖ ❖ Bidirectional Communication
Specifies, for instance, how a print-
er connected to the parallel inter-
face responds to a status request. If
you experience problems using an-
other manufacturer's printer, set
this to OFF.
Limitation
❒ If set to OFF, asynchronous
communication will not work.
• ON
• OFF
Note
❒ Default: ON
❖ ❖ ❖ ❖ Signal Control
Specifies how to handle any errors
that occur when printing from a
computer or sending faxes. Nor-
mally, you do not need to change
this setting.
• Job acceptance priority
• Printer priority
• Facsimile priority
Note
❒ Default: Job acceptance priority