Troubleshooting; Hardware Reset; Reset Admin Password; Reset Factory Defaults - Dataprobe iBoot-PDU4-N15 Manual

13.1. Hardware Reset

The hardware reset is located adjacent to the network jack on the rear
panel. Use a non-conductive pin to actuate the reset if necessary.
Momentarily depress the reset button to perform a hardware reset.
Note that outlets will reset to the status as determined by their Last State
Setting.

13.2. Reset admin password

The password for user admin can only be set within the first two minutes of powering up the iBoot-PDU.
The DMU utility has the ability to reset the admin password back to factory default:
Version 1.38 and below.............. Password: admin
Version 1.39 and above ............. Password: admin<last 3 Mac segments>
( If Mac address is 01:02:03:04:ab:06 then default Password is admin04ab06 )
ALL Passwords are case sensitive
Please see section 3.5.1 for details.

13.3. Reset Factory Defaults

Holding the hardware reset for more than 5 seconds will reset the device to its factory defaults.
While resetting all the power LEDs will flash for 5 seconds.
Note that this will also reset the IP Address settings to DHCP or 192.168.1.254 if no DHCP server is found.
iBoot-PDU_v230829w
13.

Troubleshooting

iBoot-PDU User Manual Page 84