Advertisement
Quick Links
What's Included
•
iBootBar Unit
•
Rack Mounting Ears
•
Network Cable
•
Quick Start Guide
Front Panel
Rear Panel – NEMA Versions
nd
2
Linecord
on -2N Models
Linecord for NEMA
Models
Rear Panel – IEC Versions
Circuit Breaker(s)
IEC C-14 (10 Amp) or
IEC C-20 (20 Amp) Inlets
Quick Start Defaults
IP address
User Credentials
Command Line Quick Start:
To view outlet status
To turn on off outlet 1
To reboot outlet 2
iBootBar Quick Start
Reset Pushbutton
Outlet Status
(Recessed)
Indicators
8 NEMA 5-15
Circuit Breaker(s)
Outlets
8 IEC C13 Outlets
192.168.0.254
Username: admin
Password: admin
iBootBar> get outlets
iBootBar> set outlet 1 off
iBootBar> set outlet 2 cycle
© 2015 Dataprobe Inc.
Quick Start Guide
Available Online at
dataprobe.com/support_ibootbar.html
•
Complete Product Manual
•
Device Management Utility
•
Latest iBootBar Firmware
•
Software Developer Tools
Mains (Inlet) Power
Indicators
Expansion for Cluster
Configurations
Serial
(DCE)
Network
(10/100)
nd
2
Inlet on -2C Models
Phone Line
(Modem Versions)
V150715E
Advertisement
Related Manuals for Dataprobe iBootBar
Summary of Contents for Dataprobe iBootBar
- Page 1 Password: admin Command Line Quick Start: To view outlet status iBootBar> get outlets To turn on off outlet 1 iBootBar> set outlet 1 off To reboot outlet 2 iBootBar> set outlet 2 cycle iBootBar Quick Start © 2015 Dataprobe Inc.
- Page 2 Setting the IP address using CLI Connect to the iBootBar for initial setup using the Command Line Interface (CLI) to set the IP Address. You will need to be on the same local subnet (192.168.0.xxx) to perform the initial configuration.
- Page 3 Technical Support, Returns and Warranty Dataprobe Technical Support is available 8:30AM to 5:30PM ET to assist you in the installation and operation of this product. To obtain Technical Support call 201- 934-5111, or Email us at tech@dataprobe.com. Please have the following information available when you call: •...