Dataprobe iBoot-PDU4-N15 Manual page 64

set trigger <name> hysteresis < # >
set trigger <name> repeat <once | counter |
forever>
set trigger <name> sourceip <xxx.xxx.xxx.xxx |
localhost | remote name>
set trigger <name> sourceinstance <LV1 | LV2 |
LC1 | LC2 | T0 | T1>
set trigger <name> targettriggersequence
<sequence name>
set trigger <name> targetclearsequence <sequence
name>
set trigger <name> count <count>
set trigger <name> qulifytime <qualifytime>
del trigger <name>
iBoot-PDU_v230829w
5
Forever
127.0.0.1 (localhost)
LV1 / LC1 / T0
None
None
10
10
iBoot-PDU User Manual
128 characters & special characters
This setting changes the Line Cord or
Temperature Sensor that is being monitored
for Analog Triggers. It defaults to Line 1 or
T0 (main sensor) depending on the trigger
type. This only needs to be changed to
select LV2, LC2 or T1.
Name of Sequence to run on Trigger
Name of Sequence to run on Clear Trigger
In seconds
Page 64