Dataprobe iBoot-PDU4-N15 Manual page 34

To program an AutoPing
1. Select Automation > AutoPing from the main menu.
2. Click on Add AutoPing at the top of the page.
AutoPing Settings
Name Enter a Name for the trigger. Up to 20 Alphanumeric characters, no spaces
Enable Check Enable to make the AutoPing active. The AutoPing must be disabled to
make any edits.
Show on Determines if the trigger card will display on the dashboard. If unchecked, it will
Dashboard continue to function without status display on the dashboard, if enabled
Mode Set if one (A) or two (A / B) IP addresses will be used for the test If two, then
select if AND (both must fail to trigger an action, clear if either is good), or OR,
(triggers action if either fail, clears when both are good).
iBoot-PDU_v230829w iBoot-PDU User Manual Page 34