Dataprobe iBoot-PDU4-N15 Manual page 26

To Add a remote unit
Click on the Add Remote Devices button at the top of the page.
Remote Settings
IP Address Set the IP Address in format XXX.XXX.XXX.XXX
Username Set the username for the remote unit.
administrative rights. Only outlets to which the username used has rights to will
be managed by this iBoot-PDU.
Password Set the password associated with the username above.
Delay Sets the Delay Time for the remote unit. Sets the time, in seconds between local
and remote status updates.
Click Save to complete the setup and initiate communication with the remote.
Remote Administration
The iBoot-PDU will connect with the remote unit and present Up, Down or Pending status in the upper right
corner of the remote unit's card. This same status appears on the device card on the dashboard, if the
Show on Dashboard selector is checked.
iBoot-PDU_v230829w iBoot-PDU User Manual
The username used must have
Page 26