Cisco Linksys RT31P2 Administration Manual page 39

expr = DQUOT val DQUOT
options = "[" *option "]"
option = key-opt / alias-opt / post-opt
key-opt = "--key" key-string
key-string = password / quoted-pass-phrase / hex-string
alias-opt = "--alias" val
post-opt = "--post" val
url = [ method "://"
method = "tftp" / "http" / "https"
server(**) = ip4quad / fqdn
( * ) Attribute can contain the name of any configuration parameter
( ** ) If the server and scheme are unspecified, the TFTP server name provided by the LAN's DHCP
server is used instead. Also, an FQDN with multiple DNS entries is multiply resolved by the PHONE
ADAPTER.
The variables available for macro substitution (with example values) are as follows:
PN PAP2
PSN PAP2
MA 000f66aaa010
MAU 000F66AAA010
MAC 00:0f:66:aa:a0:10
SN CH500D600862
SWVER 1.0.2
HWVER 1.0.1
UPGCOND 1.0.2<1.1
SCHEME tftp
SERV http.example.com
SERVIP 10.2.3.200
PORT 69
PATH /guest/pap2.cfg
IP 192.168.1.102
EXTIP 45.73.21.44
PRVST 0
UPGST 0
ERR corrupt file
A to P some-value
SA to SD some-value
( * ) Note that the UPGCOND term is particularly useful in the Upgrade_Rule (discussed later in this
document), but applies equally as a resync condition. It shows which term of the rule triggered the
operation.
( ** ) See section 6.5 for the values of these macro variables.
( *** ) Upon successful firmware upgrade, the ERR variable carries the version of the newly installed
load.
© 2004 Linksys Proprietary (See Copyright Notice on Page 2)
[ server [":" port]]] "/" *(dir "/") file
Product Name
Product Series Number
MAC Address
MAC Address (upper case)
MAC Addr with Colon separators
Serial Number
Firmware Version Number
Hardware Version Number
Upgrade(*) Condition
Access Scheme
Server Name
Server IP Address
TCP/IP Request Port
File path
IP address of the PHONE ADAPTER
Configured or discovered external IP
address (for example using STUN)
Error Code of Last Profile Rule(**)
Error Code of Last Upgrade Rule(**)
Error/Info(***) message
Contents of GPP_A to GPP_P
Contents of GPP_SA to GPP_SD
39