Example: Setting Up Basic Device Parameters - Cisco CSS11501S-C-K9 Configuration Manual

Chapter 4 Using the Configuration Manager

Example: Setting up Basic Device Parameters

78-13124-06
This example describes how to use the configuration manager to set the basic SSL
appliance configuration.
Initiate a serial management session, and set the IP address of the device to
1.
10.1.2.5.
SCA> enable
SCA# config
(config[CSS-SCA])# ip address 10.1.2.5 netmask 255.255.0.0
(config[CSS-SCA])#
2. If you wish to configure the server using the serial connection, continue with
step 3.
If you wish to use a telnet connection, initiate a telnet session with the IP
address assigned in step 1, and go to step 3.
Use the following commands to enter Privileged and Configuration modes
3.
and change the name of the SSL appliance to myDevice.
SCA> enable
SCA# configure
(config[CS-10-1-2-3])# hostname myDevice
(config[CS-10-1-2-3])# end
SCA# configure
(config[myDevice])#
Set the default router.
4.
(config[myDevice])# ip route default 10.1.2.1
(config[myDevice])#
Set an enable password to protect the appliance configuration. The password
5.
is requested whenever the enable command is given.
Passwords are not echoed to the screen.
Note
(config[myDevice])# password enable
Enter new password:
Confirm password:
(config[myDevice])# end
SCAE
Cisco 11000 Series Secure Content Accelerator Configuration Guide
Configuring the Device
4-7