Examples
Examples
Configuring Basic Device Parameters
Cisco 11000 Series Secure Content Accelerator Configuration Guide
D-4
The following examples demonstrate how to use MiniMax to perform these tasks:
Configure basic device parameters
•
•
Install a MaxOS image with Netcat
Install a MaxOS image with xmodem
•
Reset the MiniMax environment to factory defaults
•
Follow these steps to set the IP address, subnet mask, and default route for the
SSL device.
1.
Enter the following commands at the MiniMax prompt. (Replace the IP
address, subnet mask, and router address with appropriate ones.)
>>ip address 10.1.2.5 netmask 255.255.255.0
>>ip route default 10.1.2.254
>>
2.
Check the environment by entering the following command. An example of
the associated response is included.
>>env
cbaud=9600
autoboot=N
autorun=N
verbose=false
netaddr=10.1.2.5
netmask=255.255.255.0
gwaddr=10.1.2.254
bootfile=/flash/maxos.bz2
TZ=GMT10DST
TERM=ansi
FIPS_MODE=0
COLUMNS=80
ROWS=25
bootdevice=/flash/maxos.bz2
build=200208160004
version=4.1.0
Appendix D
MiniMax Command Summary
78-13124-06