Connecting A Css 11800 Ac Power Cord; Connecting A Css 11800 Dc Power Cord; Figure 2-19 Connecting A Css 11800 Ac Power Cord - Cisco CSS-11051-AC Hardware Installation Manual

Connecting Power Cords

Connecting a CSS 11800 AC Power Cord

Connecting a CSS 11800 DC Power Cord

Warning
Cisco 11000 Series Content Services Switch Hardware Installation Guide
2-30
To connect an AC power cord to a CSS 11800:
Ensure that the CSS power switch is in the 0 (off) position.
1.
2. Attach the power cord to the CSS by plugging the AC power cord connector
into the power receptacle at the front of the chassis as shown in

Figure 2-19 Connecting a CSS 11800 AC Power Cord

PS1 PS2
3. Plug the power cord into a dedicated 3-wire grounding receptacle.
Switch on the power on the CSS.
4.
Before you install a DC power cord, see Appendix A,
power supply safety warnings.
The DC power supply cord requires 12 AWG wire. The CSS 11800 draws a
maximum of 25 amps.
Chapter 2
PS1 power switch
PS2 power switch
PS2 AC
power cord
PS1 AC
power cord
Specifications
Cabling the CSS
Figure 2-19.
for DC
78-15146-02