Connecting A Css 11800 Power Cord; Table 2-10 Css 11150 To Dc Power Source Cabling - Cisco CSS-11051-AC Hardware Installation Manual

Chapter 2 Cabling the CSS

Connecting a CSS 11800 Power Cord

Note
78-15146-02
3. Install the wires into the appropriate connector. Make sure that the
uninsulated part of each wire is 9mm (0.35 in.) in length.
When installing the wires, always connect the ground wire first. When
disconnecting the wires, always disconnect the ground wire last.
The proper power cable wiring between the CSS 11150 and DC power source
is illustrated in Table

Table 2-10 CSS 11150 to DC Power Source Cabling

CSS 11150
(Ground)
+
–
Tighten the captive screws to 5 to 7 inch-pounds (.6 to .8 Nm) of torque to
4.
secure the wires in the connectors. Ensure the wires are held firmly in place.
The following sections provide information for connecting an AC or DC power
cord to a CSS 11800.
For information on installing a redundant AC or DC power supply, consult the
reference sheet included with the power supply.
Cisco 11000 Series Content Services Switch Hardware Installation Guide
2-10.
DC Power Source
(Ground)
+
–
Connecting Power Cords
2-29