Connecting A Css 11050 Or Css 11150 Ac Power Cord; Connecting A Css 11150 Dc Power Cord; Figure 2-17 Connecting A Css 11050 Or Css 11150 Ac Power Cord - Cisco CSS-11051-AC Hardware Installation Manual

Chapter 2 Cabling the CSS

Connecting a CSS 11050 or CSS 11150 AC Power Cord

Connecting a CSS 11150 DC Power Cord

Warning
Warning
78-15146-02
To connect an AC power cord to a CSS 11050 or CSS 11150:
Ensure that the CSS power switch is in the 0 (off) position.
1.
2. Attach the power cord to the CSS by plugging the AC power cord connector
into the power receptacle at the rear panel, as shown in

Figure 2-17 Connecting a CSS 11050 or CSS 11150 AC Power Cord

AC -100 -240 VAC
50 - 60HZ 3.1AMax.
AC power cord
Plug the power cord into a dedicated 3-wire grounding receptacle.
3.
4. Switch on the power on the CSS.
Before you install a DC power cord, see Appendix A,
power supply safety warnings.
The DC power supply cord requires 18 AWG wire. The CSS 11150 draws a
maximum of 25 amps.
DC systems do not have a power switch. A chassis configured for DC power
requires an external power disconnect device (such as an external circuit
breaker).
Cisco 11000 Series Content Services Switch Hardware Installation Guide
Connecting Power Cords
Power switch
Specifications
Figure 2-17.
for DC
2-27