Installing the CSS 11800
Figure 1-6
Aligning Brackets on the CSS 11800 Chassis for Extended Mounting
Mounting
bracket
Mounting
key
Cisco 11000 Series Content Services Switch Hardware Installation Guide
1-12
To change the location of the mounting brackets on the CSS 11800 chassis from
a front-mount position to an extended-mount position:
1.
Remove the seven front mounting bracket screws from one side of the chassis.
Align the rear screw holes on the bracket with the screw holes on the front
2.
side of the chassis. Note the bracket's proper orientation as shown in
Figure
1-6.
3.
Using a Phillips screwdriver, install the seven #10-32 pan-head screws
through the extended-mount bracket holes into the CSS.
4.
Repeat steps 1 through 3 to install the second bracket onto the other side of
the chassis.
Chapter 1
Unpacking and Installing the CSS
Mounting
bracket
Mounting
key
78-15146-02