Installing A Module - Cisco CSS-11051-AC Hardware Installation Manual

Installing a CSS 11800 Module

Installing a Module

Note
Cisco 11000 Series Content Services Switch Hardware Installation Guide
1-18
5. For the procedure on installing a module into the CSS 11800 chassis, see the
"Installing a Module"
You must power down the CSS 11800 chassis to install a module.
For the procedure on installing a passive SCM or SFM, see the
Passive SCM or SFM"
module, see the "Removing or Installing a Module"
To install a module:
1. Properly ground yourself prior to handling the module. For example, wear the
anti-static wrist strap (included in the accessory kit) and stick the copper-tape
end of the strap to an unpainted metal surface on the chassis. Make sure that
the wrist strap makes good contact with your skin.
2. Locate an open slot in the chassis for the module. See
possible slots for the module. If necessary, remove a blank panel from the
chassis to expose a slot for the module.
Chapter 1
section.
section. For information on removing and replacing a
Unpacking and Installing the CSS
"Installing a
section.
Table 1-1 to identify
78-15146-02