Low-Noise DFB Laser System
USB Connection
(USB Mini-B)
RS-485 Connection
(9-Pin Male D-Sub)
Simplified Declaration of Conformity
The full text of the EU declaration of conformity is available at the following internet address:
https://www.thorlabs.com/newgrouppage9.cfm?objectgroup_id=16787
FCC Designation
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.—Increase the separation between the equipment and receiver.—
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.—Consult
the dealer or an experienced radio/TV technician for help.
Chapter 2
Safety
Explosion Warning
This instrument must not be operated in an explosion endangered environment.
Rev. A, August 16, 2024
Remote Interlock Pin
(2.5 mm Phono Plug,
See Chapter 5)
(M8 Connector for DS12 Power Supply)
Figure 8
Rear Panel of the DFB13TK Laser System
Power Switch
DC Input
Chapter 2: Safety
Page 9
Need help?
Do you have a question about the DFB13TK and is the answer not in the manual?
Questions and answers