Where To Go Next - Cisco 2620 Configuration Manual

Where to Go Next

%LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up
%LINK-3-UPDOWN: Interface Ethernet0/1, changed state to up
%LINK-3-UPDOWN: Interface Serial0/0, changed state to up
%LINK-3-UPDOWN: Interface Serial0/1, changed state to down
%LINK-3-UPDOWN: Interface Serial0/2, changed state to down
%LINK-3-UPDOWN: Interface Serial1/0, changed state to up
%LINK-3-UPDOWN: Interface Serial1/1, changed state to down
%LINK-3-UPDOWN: Interface Serial1/2, changed state to down
<Additional messages omitted.>
Step 2
When the messages stop displaying on your screen, press Return to get the
Note
%AT-6-ONLYROUTER: Ethernet0/0: AppleTalk port enabled; no neighbors found
Step 3
The
completed a basic router configuration. However, this is not a complete configuration. At this point you
have two choices:
•
2600> enable
Password: password
2600# setup
•
Where to Go Next
At this point you can proceed to the following:
•
•
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
2-24
If you see the next message, it means that no other AppleTalk routers were found on the network
attached to the port.
prompt indicates that you are now at the command-line interface (CLI) and you have just
2600>
Run the setup command facility again and create another configuration. Enter the following:
Modify the existing configuration or configure additional features with the CLI as described in
Chapter 3, "Configuring with the Command-Line Interface."
"Chapter 3, "Configuring with the Command-Line Interface,"
configure additional features.
The Cisco IOS software configuration guide and command reference publications for more
advanced configuration topics. These publications are available on Cisco.com, the Documentation
CD-ROM that came with your router, or you can order printed copies. For more information, refer
to "Obtaining Documentation."
Chapter 2 Using the Setup Command Facility
prompt.
2600>
to learn how to use the CLI to
OL-1957-04