Dedicated Mode; Completing The Configuration - Cisco 2620 Configuration Manual

Chapter 2 Using the Setup Command Facility

Dedicated Mode

The following is an example of a 1-port, 4-wire 56-kbps DSU/CSU dedicated-mode configuration using
the setup command facility:
Do you want to configure Serial0/0 interface? [yes]:
Some encapsulations supported are
Choose encapsulation type
Switched 56k interface may either be in switched/Dedicated mode
Choose from either (switched/dedicated)
When in dds mode, the clock for sw56 module can either from line/internal.
Choose clock from (line/internal)
Note
If internal is selected, speed cannot be set to "auto." Auto-sensing is only allowed when the clock source
is line.
When in dds mode, the clock for sw56 module can either from line/internal.
Choose clock from (line/internal)
Warning: internal can be choose only when connected back to back.
Serial interface needs clock rate to be set in dce mode.
The following clock rates are supported on the serial interface.
choose clock rate from above
Configure IP on this interface? [yes]:

Completing the Configuration

When you have provided all the information prompted for by the setup command facility, the
configuration appears. Some examples of the configurations of the Cisco 2600 Series, Cisco 3600 series,
and Cisco 3700 series routers are shown
To complete your router configuration, do the following:
Step 1
A setup command facility prompt asks if you want to save this configuration.
If you answer no, the configuration information you entered is not saved, and you return to the router
enable prompt (
If you answer yes, the configuration is saved and your are returned to the EXEC prompt
Use this configuration? {yes/no} : yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
OL-1957-04
ppp/hdlc/frame-relay/lapb/atm-dxi/smds/x25
auto, 2.4, 4.8, 9.6, 19.2, 38.4
56, 64
IP address for this interface: 1.0.0.1
Subnet mask for this interface [255.0.0.0] :
Class A network is 1.0.0.0, 8 subnet bits; mask is /8
). Type setup to return to the System Configuration Dialog.
2600#
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
[ppp]:
[switched]: dedi
[line]:
[line]: internal
[56]:
inAppendix A, "Configuration Examples."
Completing the Configuration
.
(2600>)
2-23