Configuring Ilmi On The Dslam Connected To The Adsl Wan; Verifying Atm Configuration - Cisco 2620 Configuration Manual

Configuring 1-Port G.SHDSL WAN Interface Card
Step 14
Step 15

Configuring ILMI on the DSLAM Connected to the ADSL WAN

The ILMI protocol allows DSLAMs to be used for ATM address registration across an ATM
User-Network Interface (UNI). If ILMI is configured on the G.SHDSL WIC, the ATM PVC must be
configured on the DSLAM. All switch terminating connections use interface 0/0 to connect to the switch
CPU.
For information about configuring the DSLAM, see the
NI-2.

Verifying ATM Configuration

Use the following commands to verify your configuration:
•
•
•
•
•
•
•
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
3-62
Command
Router# show interface atm 1/0
Router# clear interface atm 1/0
To verify current configuration and to view the status for all controllers, use the show
running-config command.
To view ATM controller statistics, use the show controllers atm slot/port command.
To verify the PVC status, use the show atm vc command. Make sure that active PVCs are up.
To help identify ATM related events as they are generated, use the debug atm events command.
To indicate which interfaces are having trouble, use the debug atm errors command.
To identify an entry for the ATM interface you configured and to show an entry for the ATM
slot/port you configured, use the show ip route command.
To view the status of an ATM interface, use the show interface atm command. Make sure that the
ATM slot/port and the line protocol are up, as shown in the following examples:
Router# show interface atm 1/0
ATM1/0 is up, line protocol is up
Hardware is DSLSAR (with Globespan G.SHDSL Module)
MTU 4470 bytes, sub MTU 4470, BW 800 Kbit, DLY 2560 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
Keepalive not supported
Encapsulation(s):AAL5 AAL2, PVC mode
24 maximum active VCs, 256 VCs per VP, 2 current VCCs
VC idle disconnect time:300 seconds
Last input never, output 00:00:01, output hang never
Last clearing of "show interface" counters 03:16:00
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
2527 packets input, 57116 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
10798 packets output, 892801 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Router# show atm vc
VCD /
Chapter 3 Configuring with the Command-Line Interface
Purpose
Verifies the ATM interface configuration.
Permits the configuration changes to take effect.
Configuration Guide for Cisco DSLAMs with
Peak Avg/Min Burst
OL-1957-04