Cisco 2620 Configuration Manual page 40

Configuring Global Parameters
Serial0/1
Serial0/2
Step 4
Enter a host name for the router (this example uses 2600):
Configuring global parameters:
Enter host name [Router]: 2600
The enable secret is a password used to protect access to privileged EXEC and
configuration modes. This password, after entered, becomes encrypted in the configuration.
Step 5
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
viewing the configuration:
Enter enable secret: xxxx
The enable password is used when you do not specify an enable secret password, with some
older software versions, and some boot images.
Step 6
Enter an enable password that is different from the enable secret password. This password is not
encrypted (less secure) and can be seen when viewing the configuration:
Enter enable password: guessme
The virtual terminal password is used to protect access to the router over a network
interface.
Step 7
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports
other than the console port:
Enter virtual terminal password: guessagain
Step 8
Respond to the following prompts as appropriate for your network:
Configure SNMP Network Management? [yes]:
Community string [public]:
Configure LAT? [no]:
Configure AppleTalk? [no]:
Configure DECnet? [no]:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Note
Configure CLNS? [no]:
Configure IPX? [no]:
Configure Vines? [no]:
Configure XNS? [no]:
Configure Apollo? [no]:
Configure bridging? [no]:
Step 9
Configure the ISDN switch type used by the Basic Rate Interface (BRI) module:
BRI interface needs isdn switch-type to be configured
Valid switch types are :
[0] none..........Only if you don't want to configure BRI.
[1] basic-1tr6....1TR6 switch type for Germany
[2] basic-5ess....AT&T 5ESS switch type for the US/Canada
[3] basic-dms100..Northern DMS-100 switch type for US/Canada
[4] basic-net3....NET3 switch type for UK and Europe
[5] basic-ni......National ISDN switch type
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
2-4
unassigned
unassigned
Your IGRP autonomous system number [1]: 15
If you answer no to IGRP, you are prompted to configure RIP.
NO unset up
NO unset up
Chapter 2 Using the Setup Command Facility
down
down
OL-1957-04