Prerequisites; Configuration Tasks; Configuring The Adsl Port On The Adsl Wan Interface Card - Cisco 2620 Configuration Manual

Chapter 3 Configuring with the Command-Line Interface

Prerequisites

A 1-Port ADSL WIC must be installed in the router to match the DSL service to be configured.

Configuration Tasks

See the following sections for configuration tasks for this feature. Each task in the list is identified as
either required or optional:
•
•
Features used on the ADSL WAN interface card must also be configured on the DSLAM. See the
documentation for the specific DSLAM for information about configuring features.

Configuring the ADSL Port on the ADSL WAN Interface Card

To configure an ADSL port on the ADSL WAN interface card, complete the following steps:
Command
Step 1
Router> configure terminal
Step 2
Router(config)# interface
atm slot/port
Step 3
Router(config-if)# ip
address IP-address
Step 4
Router(config-if)# pvc
[name] vpi/vci
Step 5
Router(config-if-vc)#
protocol ip IP-address
Step 6
Router(config-if-vc)# vbr-rt
peak-rate average-rate burst
Step 7
Router(config-if-vc)#
encapsulation {aal2 |
aal5ciscoppp | aal5mux |
aal5nlpid | aal5snap}
OL-1957-04
Configuring the ADSL Port on the ADSL WAN Interface Card
Verifying ATM Configuration
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
(optional)
Purpose
Enter global configuration mode.
Enter ATM configuration mode for the ATM interface in
the specified slot and port.
Assign an IP address to the ADSL ATM interface.
Entes atm-virtual-circuit (interface-atm-vc) configuration
mode, and configures a new ATM PVC by assigning a
name (optional) and virtual path identifier (VPI)/virtual
channel identifier (VCI) numbers.
The default traffic shaping is UBR; the default
encapsulation is AAL5+LLC/SNAP.
(Optional) Enable IP connectivity and create a
point-to-point IP address for the virtual circuit (VC).
(Optional) Configure the PVC for real-time variable bit
rate (VBR) traffic shaping.
•
peak rate—Peak information rate (PIR)
•
average rate—Average information rate (AIR)
•
burst—Burst size in cells
(Optional) Configure the ATM adaptation layer (AAL) and
encapsulation type.
•
aal2—AAL2
•
aal5ciscoppp—Cisco PPP over AAL5
•
aal5mux—AAL5+MUX
•
aal5nlpid—AAL5+NLPID
•
aal5snap—AAL5+LLC/SNAP (the default)
Configuring 1-Port ADSL WAN Interface Card
(required)
3-31