Configuration Example; Configuring 1-Port G.shdsl Wan Interface Card - Cisco 2620 Configuration Manual

Configuring 1-Port G.SHDSL WAN Interface Card

Step 2
Step 3
This configuration procedure ensures that a user trying to dial out using Telnet is connected to the first
free line in the rotary group.

Configuration Example

Refer to
for an example of the configuration.
Configuring 1-Port G.SHDSL WAN Interface Card
This section describes how to configure the Multirate Symmetrical High-Speed Digital Subscriber Line
(G.SHDSL) feature supported on the 1-port G.SHDSL WAN interface card (WIC) (WIC-1SHDSL) on
Cisco 2600 series and Cisco 3600 series routers in Cisco IOS Release 12.2(4)T.
This section includes the following sections:
•
•
•
•
G.SHDSL is ATM-based, multirate, high-speed (up to 2.3 MB), symmetrical digital subscriber line
digital data transfer between a single customer premises equipment (CPE) subscriber and a central
office.
G.SHDSL is supported on the G.SHDSL WAN interface card, a 1-port WAN interface card (WIC) for
Cisco 2600 series and Cisco 3600 series routers.
The G.SHDSL WIC is compatible with the Cisco 6015, Cisco 6130, Cisco 6160, and Cisco 6260 Digital
Subscriber Line Access Multiplexers (DSLAMs). The DSLAM must be equipped with G.SHDSL line
cards that are compatible with the DSL service to be configured.
The G.SHDSL WIC supports ATM Adaptation Layer 2 (AAL2), ATM Adaptation Layer 5 (AAL5), and
various classes of quality of service (QoS) for both voice and data service.
Listed below are some benefits of this feature:
•
•
•
•
•
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
3-58
rotary number
transport input telnet
theAppendix A, "Cisco 3640 Central Site Configuration to Support ISDN and Modem Calls"
Restrictions, page 3-59
Prerequisites, page 3-59
Configuration Tasks, page 3-59
Configuration Examples, page 3-64
Enables business-class broadband service with voice integration, scalable performance, flexibility,
and security.
Aggregates G.SHDSL and other transport options into a single box.
Provides G.SHDSL high-speed digital data transmissions between customer premises equipment
(CPE) and the central office (CO), or between routers located within a customer site.
Supports ITU G.991.2 (SHDSL).
Supports ANSI T1.601 (BRI), ANSI T1.410 (DDS), and ANSI T1.403 (T1 carrier).
Chapter 3 Configuring with the Command-Line Interface
Set the router to use previously-defined rotary
group.
Configure the router to accept inbound Telnet
connections.
OL-1957-04