Configuring G.shdsl On A Cisco Router - Cisco 2620 Configuration Manual

Configuring 1-Port G.SHDSL WAN Interface Card
•
•

Configuring G.SHDSL on a Cisco Router

To configure G.SHDSL service on a Cisco router containing a G.SHDSL WIC, complete the following
steps, beginning in global configuration mode:
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
3-60
Configuring ILMI on the DSLAM Connected to the ADSL WAN, page 3-62
Verifying ATM Configuration, page 3-62
Command
Router(config)# interface atm
1/0
Router(config-if)# ip-address
IP-address
Router(config-if)# atm
ilmi-keepalive seconds
Router(config-if)# pvc [name]
vpi/vci
Router(config-if-vc)# protocol
ip IP-address
Router(config-if-vc)# vbr-rt
peak-rate average-rate burst
Chapter 3 Configuring with the Command-Line Interface
(optional)
Purpose
Enters ATM configuration mode for interface ATM 0 in
slot 1.
Note
If a slot has two subslots for WIC modules and no
ATM interface is present in subslot 0, the WIC
will take ATM x/0 as its interface number even if
placed in subslot 1 (ATMx/1).
If a two-port ATM module is present in subslot
0, the WIC will use ATM x/2 as its interface
number. This subslot number is pertainent to all
interface commands such as show interface atm
and show dsl interface atm.
Assigns an IP address to the DSL ATM interface.
(Optional) Enables Integrated Local Management
Interface (ILMI) keepalives.
If you enable ILMI keepalives without specifying the
seconds, the default time interval is 3 seconds.
Enters atm-virtual-circuit (interface-atm-vc)
configuration mode, and configures a new ATM
permanent virtual circuit (PVC) by assigning a name
(optional) and VPI/VCI numbers.
The default traffic shaping is UBR; the default
encapsulation is AAL5+LLC/SNAP.
(Optional) Enables IP connectivity and create a
point-to-point IP address for the virtual circuit (VC).
(Optional) Configures the PVC for real-time variable bit
rate (VBR) traffic shaping.
•
Peak rate—Peak information rate (PIR)
•
Average rate—Average information rate (AIR)
•
Burst—Burst size in cells
(optional)
OL-1957-04