Configuring With The Command-Line Interface - Cisco 2620 Configuration Manual

Configuring with the Command-Line Interface

This chapter describes how to use the Cisco IOS software command-line interface (CLI) to configure
basic router functionality, including:
•
Configuring the Host Name and Password, page 3-2
•
Configuring 1-Port and 2-Port Ethernet Interfaces, page 3-3
•
Configuring Fast Ethernet Interfaces, page 3-4
•
Configuring Asynchronous/Synchronous Serial Network Modules or WAN Interface Cards, page
3-5
•
Configuring 16-Port and 32-Port Asynchronous Network Modules, page 3-9
•
Configuring ISDN BRI WAN Interface Cards, page 3-10
•
Configuring T1 and E1 Interfaces, page 3-14
•
Configuring T1 (FT1) WAN Interface Cards, page 3-18
•
Configuring ATM Interfaces, page 3-20
•
Configuring Inverse Multiplexing for ATM Interfaces, page 3-22
•
Configuring Analog Modem Interfaces, page 3-26
•
Configuring Wireless Multipoint Interfaces, page 3-28
•
Configuring 1-Port ADSL WAN Interface Card, page 3-29
•
Configuring the NM-AIC-64, Contact Closure Network Module, page 3-34
•
Configuring the 1-Port HSSI Network Module, page 3-46
•
Configuring the Compression Network Module for the Cisco 3600 Series Routers, page 3-49
•
Configuring the Digital Modem Network Module for the Cisco 3640 Router, page 3-50
•
Configuring G.SHDSL on a Cisco Router, page 3-60
•
Where to Go Next, page 3-64
Follow the procedures in this chapter to configure the router manually, or if you want to
change the configuration after you have run the setup command facility
Facility, page
This chapter does not describe every configuration possible—only a small portion of the most commonly
used configuration procedures. For advanced configuration topics, refer to the Cisco IOS configuration
guide and command reference publications. These publications are available on the Documentation
CD-ROM that came with your router, on the World Wide Web from Cisco's home page, or you can order
printed copies separately.
OL-1957-04
2-1.
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
C H A P T E R
Using the Setup Command
3
3-1