Cisco 2620 Configuration Manual page 49

Chapter 2 Using the Setup Command Facility
Choose encapsulation type
Note
The following sections describe the prompts for each encapsulation type. No further configuration is
needed for HDLC encapsulation.
Do you have a service profile identifiers (SPIDs) assigned? [no]: y
Enter SPID1: 12345
Enter SPID2: 12345
Note
The setup command facility only prompts for the SPID number if you specify basic-5ess, basic-ni1, or
basic-dms100 for the switch type.
Do you want to map the remote machine's IP address in dialer map? [yes]:
IP address for the remote interface: 2.0.0.1
Do you want to map the remote machine's IP address in dialer map? [yes]:
IPX address of the remote interface: 40.0060.34c6.90ed
To get to 2.0.0.1 we will need to make a phone call.
Please enter the phone number to call: 1234567890
Configure IP on this interface? [yes]:
Note
If your router has at least one configured LAN interface, you can choose to use an unnumbered IP
address on the interface.
Configure IP unnumbered on this interface? [no]: y
Assign to which interface [Ethernet0/0]:
Note
If your router does not have a configured LAN interface, you must use a numbered IP address.
IP address for this interface: 2.0.0.0.1
Enter the subnet mask [255.0.0.0]:
PPP Encapsulation
Would you like to enable multilink PPP [yes]:
Enter a remote hostname for PPP authentication [Router]:
Enter a password for PPP authentication:
Note
The password, which is used by the Challenge Handshake Authentication Protocol (CHAP)
authentication process, is case sensitive and must match the remote router's password exactly.
Frame Relay Encapsulation
The following lmi-types are available to be set,
when connected to a frame relay switch
Enter lmi-type [2]:
OL-1957-04
[ppp]:
[0] none
[1] ansi
[2] cisco
[3] q933a
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Configuring Interface Parameters
2-13