Class Set - Asus GIGAX2048 User Manual

4.9.3

Class Set

This configuration page is used to create QoS classes. A class set is a
mechanism that you use to isolate a specific traffic flow (or class) from all
other traffic. The class set defines the criteria (match mode) used to match
a specific traffic flow to further classify it. The criteria can include matching
ACL rule in a Filter Set ID or DSCP list. Only one match mode and only one
ACL rule for each class set are supported. After a packet is matched
against the class-map criteria, it will be further classified through
corresponding policy set. The switch only can have 56 classes. The
following fields are available:
• Class Name: input a class name. The Class names can not be
duplicate.
• Match: select a match mode.
• Filter Set ID: if the match mode is 'Filter', users must select an
existed filter set ID.
• DSCP: if the match mode is 'DSCP', users must input DSCP values.
Click on
Then you will see the new added entry shows in the class list. Click on
to select the class that you want to modify. Editing the class, then click on
. You will see the modified entry shows in the class list. Click on
to select the class that you want to remove, then click on
remove it. To make the configuration effective, please go to "Save
Configuration" page, then click on
GigaX Series L2 Managed Switch User Guide
after you create a new class by the above information.
.
to