Table 7. Boot Rom Commands - Asus GIGAX2048 User Manual

Table 7. Boot ROM commands
Command Parameters
d Address
[length]
p NONE
g NONE
a NONE
b 0 or 1 or a
s 0, 1, 2, 3
x NONE
r NONE
w NONE
GigaX Series L2 Managed Switch User Guide
Usage
Dump memory contents by
giving address and length.
Display current boot parameters
Execute firmware, enter CLI
mode
Show MAC address
Dual image support. You can
choose the firmware to execute
by giving a slot ID, or use "a" for
auto select. Auto-select will
execute the most updated
firmware. This is the default
setting
Set the console baud rate. 0:
9600bps 1:38400bps
2:57600bps 3:115200bps
Upload firmware to the switch
Toggle the safe mode
Toggle administrator password
reset
Notes
When you fail in
firmware update, you
can use this command to
boot up the switch using
the old firmware.
Change it back to
auto-select mode after
successfully updating
the firmware.
You have to set up the
terminal emulator with
the same baud rate to
make the work
It is slow to update
firmware by the console
port. If you lost network
connection to switch,
you can still update
firmware in this way
When a configuration file
is corrupt or you forget
your password, use safe
mode to enter CLI mode.
Your configuration file is
lost in this mode. You
need to restore your
configuration, or
re-configure the system
Reset user ID and
password once to default
value. Your configuration
settings will not be
changed.