Asus GIGAX2048 User Manual page 156

GigaX Series L2 Managed Switch User's Guide
Problem
You forgot/lost your
WEB Configuration
Interface user ID or
password.
Some pages do not
display completely
Changes to
Configuration are
not being retained.
Console Interface
Cannot show the
texts on the terminal
emulator.
156
1. If you have not changed the password from the default, try using
"admin" as the user ID and bypassing password.
2. Login to console mode through RS232 or USB, use "sys user
show" to display the lost information
1. Verify that you are using Internet Explorer v5.5 or later.
Netscape is not supported. Support for Javascript® must be
enabled in your browser. Support for Java® may also be
required.
2. Ping the switch IP address to see if the link is stable. If some
ping packets fail, check your network setup to make sure a valid
setting.
Be sure to click on
page to save any changes.
1. The factory default baud rate is 9600, no flow control, 8 bit data,
no parity check and stop bit is one.
2. Change your terminal emulator setup to this number. If you are
using USB to connect the switch, install the USB driver first.
3. Check if the cable is good.
Suggested Action
button in the Save Configuration