Trap Setting; Vacm Group; Figure 40. Trap Setting - Asus GIGAX2048 User Manual

4.6.3

Trap Setting

By setting trap destination IP addresses and community names, you can
enable SNMP trap function to send trap packets in different versions (v1 or
v2c). Click
to refresh the page.
4.6.4

VACM Group

VACM (View-based Access Control Model) Group is used to configure the
information of SNMPV3 VACM Group.
Group Name: enter the security group name.
Read View Name: enter the Read View Name that the Group
belongs. The related SNMP messages are Get, GetNext, GetBulk.
Write View Name: enter the Write View Name that the Group
belongs. The related SNMP message is Set.
GigaX Series L2 Managed Switch User Guide
to save the configuration permanently or

Figure 40. Trap Setting