Table of Contents
Advertisement
Default User Name:
Default Password:
3. To setup a new IP address, click "System", then "IP Setup" (see
Figure 8). Fill in the IP address, network mask and default gateway,
then click
4. If your new address is different from the default, the browser can not
update the switch status window or retrieve any page. This is
normal. You have to retype the new IP address in the
address/location box, and press <Enter>. The WEB link returns.
5. To enable authentication for Web access, click "Administration" on
the menu list, then select "Enabled" to start the protection.
A login window appears immediately after you click
figures on the next page.
GigaX Series L2 Managed Switch User Guide
admin
(no password)
You can change the password at any time (see section
5.3.1 System Commands).
.
Note that the GigaX 2048 and 2024 models have the
same web interface, except for the front panel image on
top of the screen (see figures on the next page).
The following sections show only one screen image (that
of the GigaX 2048 model) if the screen contents for both
models are the same. Both the GigaX 2048 and 2024
screens are shown when the screen contents are
different.
. See the
Advertisement
Table of Contents
Troubleshooting
