GigaX Series L2 Managed Switch User's Guide
4.9.2
Mapping
This page is used to configure CoS (Classification of Service) and DSCP
(Differentiated Services Code Point) mapping.
• Map CoS to DSCP: each CoS value can map into one of the DSCP
value. Users can use the CoS-to-DSCP map to map CoS values in
incoming packets to a DSCP value that QoS uses internally to
represent the priority of the traffic.
• Map DSCP to CoS: each DSCP value can map into one of the CoS
value. Users can use the DSCP-to-CoS map to map DSCP values in
incoming packets to a CoS value, which is used to select one of the
four egress queues.
Click on
refresh the settings to current value. To make the configuration effective,
please go to "Save Configuration" page, then click on
88
to save the configuration. Click on
Figure 56. Mapping
to
.