Troubleshooting - HOMCOM 823-057V70 Use And Care Manual

1. lf the appliance will not be used for a long time, be sure to Pull out the primary and
the secondary rubber plug of the drain port , in order to drain the water.
2. Keep the appliance running with fan only for a half day during a sunny day to dry the
appliance inside and prevent from going moldy.
3. Stop the appliance and pull out the power supply plug, then take out the batteries of
remote controller and store appliance properly.
4. Clean the air filter and reinstall it.
5. Remove the air hoses and store them properly, and cover the hole tightly.

Troubleshooting

The following cases may not always be a malfunction, please check suggestions
below before asking for service.
Trouble
Does not run
Runs for a short while only
Water leak duringmoving
Water leak during moving
Maintenance after using
lf the protector trip or fuse is blown.
•
Please wait for 3 minutes and start again,
•
protector device may be preventing unit from
working.
lf batteries in the remote controller are
•
exhausted.
lf the plug is not properly plugged in.
•
lf the set temperature is close to room
•
temperature, you can lower the set
temperature.
Air outlet is blocked by obstacle. Take the
•
obstacle away.
lf the door or window is open.
•
lf there is another appliance heat-working.like
•
heater or lamp, etc. .
The air filter is dirty, please clean it.
•
Air outlet or intake is blocked.
•
Set temperature is too high.
•
Drain the condensate before moving.
•
To avoid water leakage, please locate the unit
•
on flat ground..
12
Analysis