Safety
Before you start
Please read the following instructions carefully before using the local air
conditioner and retain for further reference
CAUTION: FIREELECTRIC SHOCKPHYSICALINJURYAND
PROPERTYDAMAGE HAZARDS.
● To use the local air conditioner, always follow the instructions for assembly use and
maintenance as well as usage cautions
● Do not wet the housing or control panel.
● Do not cover the air outlet while in use.
● Do not allow children to play with the control or drop any objects into the air outlet.
● Do not place any objects or let any person sit on top of the unit.
● Always turn the unit off and remove the power plug from the socket when cleaning or
for any other maintenance operation.
● Do not attempt to remove any part of the casing unless by an authorised technician.
● Remove the plug from the socket if the unit is not being used for a long period.
● Always connect this appliance to a 220-240 V~mains power socket.
● Do not operate the unit with damaged plug or loose socket point.
● Do not use means to accelerate the defrosting process or to clean, other than those
recommended by the manufacturer.
● The appliance shall be stored in a room without continuously operating ignition
sources (for example: open flames, an operating gas appliance or an operating
electric heater).
● Do not pierce or burn. Be aware that refrigerants may not contain an odour.
● Appliance shall be installed. operated and stored in a room with a floor area larger
2
than4m for model FDP20-2026R5 7.7m for model FDP26-2026R5.
WARNING: KEEP VENTILATION OPENING CLEAR OF
OBSTRUCTION.
Servicing shall be performed only as recommended by the manufacturer.
•
WARNING: THE APPLIANCE SHALL BE STORED IN A WELL-
VENTILATED AREA WHERE THE ROOM SIZE CORRESPONDS
TO THE ROOM AREA AS SPECIFIED FOR OPERATION.
WARNING: THE APPLIANCE SHALL BE STORED IN A ROOM
WITHOUT CONTINUOUSLY OPERATING OPEN FLAMES (FOR
.EXAMPLE AN OPERATING GAS APPLIANCE) AND IGNITION
SOURCES(FOR EXAMPLE AN OPERATING ELECTRIC HEATER).
.
● Under no circumstances shall potential sources of ignition be used in the searching
for or detection of refrigerant leaks. A halide torch (or any other detector using a
naked flame)shall not be used.
2
3
Need help?
Do you have a question about the 823-057V70 and is the answer not in the manual?
Questions and answers