Snmp - TRENDnet TEW-453APB User Manual

SNMP

SNMP (Simple Network Management Protocol) is only useful if you have a SNMP program
on your PC. To reach this screen, select SNMP in the Management section of the menu.
Data - SNMP Screen
General
Enable SNMP
Community
Access Rights
Managers
Any Station
Only this station
Traps
Disable
Broadcast
Send to
Trap version
Figure 59: SNMP Screen
Use this to enable or disable SNMP as required
Enter the community string, usually either "Public" or "Private".
Select the desired option:
•
Read-only - Data can be read, but not changed.
•
Read/Write - Data can be read, and setting changed.
The IP address of the manager station is not checked.
The IP address is checked, and must match the address you enter in
the IP address field provided.
If selected, you must enter the IP address of the required station.
Traps are not used.
Select this to have Traps broadcast on your network. This makes
them available to any PC.
Select this to have Trap messages sent to the specified PC only. If
selected, you must enter the IP Address of the desired PC.
Select the desired option, as supported by your SNMP Management
program.
Access Point Management
77