Table of Contents Table of Contents English ...................... 1. Before You Start ................. 2. Install Hardware ................. 3. Configure the Access Point ..............Troubleshooting ..................Version 04.04.2006...
1. Before You Start Package Content TEW-450APB Quick Installation Guide External Power Adapter User’s Guide CD-ROM 1 x 2dBi Detachable Antenna Installation Requirements A web browser such as Internet Explorer (5.5 or higher) or Netscape Navigator (4.7 or higher). A computer with a network adapter properly installed.
Note: Locate an optimum location for the Access Point. The best place for the Access Point is usually at the center of your wireless network. Please connect the computer configuring the TEW-450APB to the same switch/hub. 1. Connect a RJ-45 cable from the...
3. Configure the Access Point Note: It is recommended that you configure the Access Point from a wired computer. Before the Access Point can be configured, a Static IP address must be assigned ton your computer's network adapter in the subnet of 192.168.1.x.
Page 6
4. Click Next. 5. Enter a new password for your Access Point, verify the new password, and then click Next. (If a new password is not entered, the default password admin will be used. 6. Enter a SSID for your Access Point and then click Next.
Page 7
7. Enable Encryption if needed and then click Next 8. Click Restart. 9. Click Close. Your installation is now complete. For detailed information regarding the TEW-450APB's configuration and advanced settings, please refer to the Troubleshooting section, User's Guide CD-ROM, or Trendnet's website at http://www.trendnet.com. English...
I specified the IP address http://192.168.1.100 in my Internet Browser's Address Bar, but an error message says "The page cannot be displayed". How can I get into the TEW-450APB's web configuration page? First, check your hardware settings again by following the instructions in section 2.
Page 9
15 seconds, then plug the power back in. Third, contact the manufacturer of your wireless network adapter. Make sure the wireless network adapter is configured with the proper SSID. The default SSID of the Access Point is TRENDnet. If you still encounter problems or have any questions regarding the TEW-450APB, please contact TRENDnet's Technical Support Department.
Need help?
Do you have a question about the TEW-450APB and is the answer not in the manual?
Questions and answers