Auto Config/Update - TRENDnet TEW-453APB User Manual

Auto Config/Update

The Auto Config/Update screen provides two (2) features:
•
Auto Config - The Access Point will configure itself by copying data from another
(compatible) Access Point.
•
Auto Update - The Access Point will update its Firmware by downloading the Firmware
file from your FTP Server.
Data - Auto Config/Update Screen
Admin Connections
Perform Auto Configu-
ration on this AP next
restart
Respond to Auto-
configuration request by
other AP
Figure 55: Auto Config/Update Screen
If checked, this AP will perform Auto Configuration the next
time it restarts.
The wired LAN (NOT the Wireless LAN) will be searched
for compatible APs.
If a compatible AP is found, its configuration is copied. If
more than one compatible AP exists, the first one found is
used.
Some data cannot be copied:
•
The IP address is not copied, and will not change.
•
The operating mode ( Repeater, Bridge, etc) is not copied,
and will not change.
Note: This checkbox is automatically disabled after Auto-
configuration, so the Auto-configuration is only performed
once.
If checked, this AP will respond to "Auto Configuration"
requests it receives. If not checked, "Auto Configuration"
requests will be ignored.
Access Point Management
71