Installing The Control Panel Assembly - Dell PowerEdge 2970 Hardware Owner's Manual

Figure 3-34. Control Panel Removal
3
2
1
1 display module label
4 display module cable
7 control-panel circuit board
securing screws (3)

Installing the Control Panel Assembly

1 Insert the display module into the chassis cutout and secure with the two Torx screws.
2 Affix the display module label to the display module.
3 Install the control panel board in the system chassis and secure with the three Phillips screws. See
Figure 3-34.
4 Connect the display module cable to the control panel board. See Figure 3-34.
5 Connect the control panel cable to the control panel board. See Figure 3-34.
6 Close the system. See "Closing the System" on page 56.
110
Installing System Components
4
2 display module securing
screws (2)
5 control panel cable
5
6
7
3 display module
6 control panel circuit board