Dell PowerEdge 2970 Hardware Owner's Manual page 25

Table 1-6. LCD Status Messages (continued)
Code Text
E1810 HDD ## Fault
HDD ## Rbld Abrt The specified hard drive has
E1811
E1812 HDD ## Removed
E1914 DRAC5 Conn2 Cbl
E1A12 PCI Rsr Missing
E1A14 SAS Cable A
E1A15 SAS Cable B
E2010 No Memory
E2011 Mem Config Err
E2012 Unusable Memory
Shadow BIOS Fail The system BIOS failed to copy
E2013
E2014 CMOS Fail
E2015 DMA Controller
E2016 Int Controller
Causes
The SAS subsystem has
determined that hard drive ##
has experienced a fault.
experienced a rebuild abort.
The specified hard drive has been
removed from the system.
DRAC 5 cable is missing or
disconnected.
One or all of the PCIe risers is
missing, preventing the system
from powering on.
SAS cable A is missing or bad.
SAS cable B is missing or bad.
No memory is installed in the
system.
Memory detected, but is not
configurable. Error detected
during memory configuration.
Memory is configured, but not
usable. Memory subsystem
failure.
its flash image into memory.
CMOS failure. CMOS RAM not
functioning properly.
DMA controller failure.
Interrupt controller failure.
Corrective Actions
See "Troubleshooting a Hard
Drive" on page 129.
See "Troubleshooting a Hard
Drive" on page 129. If the
problem persists, see your RAID
documentation.
Information only.
Reconnect the cable. See
"Installing a RAC Card" on
page 81.
Reinstall the missing riser card(s).
Reseat the cable. If the problem
persists, replace cable. See "SAS
Controller Daughter Card" on
page 65.
Reseat the cable. If the problem
persists, replace cable. See "SAS
Controller Daughter Card" on
page 65.
Install memory. See "Installing
Memory Modules" on page 94.
See "Troubleshooting System
Memory" on page 124.
See "Troubleshooting System
Memory" on page 124.
See "Troubleshooting System
Memory" on page 124.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
About Your System
25