Dell PowerEdge 2970 Hardware Owner's Manual page 21

Table 1-6. LCD Status Messages (continued)
Code Text
E1211 ROMB Batt
E1214 ## PwrGd
E1216
E1217
PCI Rsr 5V PwrGd The 5V voltage regulator on the
E1218
E1226 PCI Rsr 1.5V
PwrGd
E1227 Linear PwrGd
E1229 CPU # VCORE
E122A CPU VTT PwrGd
E122D CPU # VDDIO
1.0V PwrGd
E122E CPU # VDDA
E122F 2.5V PwrGd
E1231 1.2V HTCORE
PwrGd
E1232 GC Fatal1 PwrGd
GC Alert1 PwrGd
VDD 12V PS#
PwrGd
E1310 RPM Fan ##
Causes
RAID battery is either missing,
bad, or unable to recharge due to
thermal issues.
Specified voltage regulator has
failed.
PCI riser has failed.
The 1.5V voltage regulator on the
PCI riser has failed.
Linear voltage regulator(s) has
failed. Represents status of
multiple voltage regulators used
in the video and LOM circuitry.
Processor # VCORE voltage
regulator has failed.
Processor # VTT voltage has
exceeded the allowable voltage
range
Processor # VDDIO voltage has
exceeded the allowable voltage
range
Processor # VDDA voltage has
exceeded the allowable voltage
range
2.5V voltage regulator has failed. See "Getting Help" on page 147.
1.2V HTCORE voltage regulator
has failed.
VLDT voltage regulator has
failed.
The specified power supply has
failed or has been removed from
the bay while the system was on.
RPM of specified cooling fan is
out of acceptable operating range.
Corrective Actions
Reseat the RAID battery
connector. See "RAID Battery" on
page 69, and "Troubleshooting
System Cooling Problems" on
page 123.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
See "Getting Help" on page 147.
If removed, reinsert the power
supply into the bay and reconnect
to power. For component failures,
see "Getting Help" on page 147.
See "Troubleshooting System
Cooling Problems" on page 123.
About Your System
21