Dell PowerEdge 2970 Hardware Owner's Manual page 32

Table 1-7. System Messages (continued)
Message
PCIe Degraded Link Width
Error: Embedded device
Expected Link Width is n
Actual Link Width is n
PCIe Degraded Link Width
Error: Integrated device
Expected Link Width is n
Actual Link Width is n
PCIe Degraded Link Width
Error: Slot n
Expected Link Width is n
Actual Link Width is n
PCIe Fatal Error caused a
system reset: Embedded
device
Please check the system
event log for details.
PCIe Fatal Error caused a
system reset: Integrated
device
Please check the system
event log for details.
PCIe Fatal Error caused a
system reset: Slot n
Please check the system
event log for details.
PCIe Training Error:
Embedded device
PCIe Training Error:
Integrated device
32
About Your System
Causes
Faulty system board or riser board.
The specified PCIe device is faulty or
improperly installed.
Faulty or improperly installed PCIe
card in the specified slot.
Faulty system board or riser board.
The specified PCIe device is faulty or
improperly installed.
Faulty or improperly installed PCIe
card in the specified slot.
Faulty system board or riser board.
The specified PCIe device is faulty or
improperly installed.
Corrective Actions
See "Getting Help" on page 147.
For a SAS controller daughter card,
reseat the card in the dedicated PCIe
connector. See "Installing a SAS
Controller Daughter Card" on page 65.
If the problem persists, see "Getting
Help" on page 147.
Reseat the PCIe card in the specified
slot number. See "Expansion Cards" on
page 72. If the problem persists, see
"Getting Help" on page 147.
See "Getting Help" on page 147.
For a SAS controller daughter card,
reseat the card in the dedicated PCIe
connector. See "Installing a SAS
Controller Daughter Card" on page 65.
If the problem persists, see "Getting
Help" on page 147.
Reseat the PCIe card in the specified
slot number. See "Installing an
Expansion Card" on page 72. If the
problem persists, see "Getting Help" on
page 147.
See "Getting Help" on page 147.
For a SAS controller daughter card,
reseat the card in the dedicated PCIe
connector. See "Installing a SAS
Controller Daughter Card" on page 65.
If the problem persists, see "Getting
Help" on page 147.