Summary of Contents for Dakota Digital LED Tail Lights for 1972 Impal LAT-NR181
Page 1
MAN#650246 Kit Includes: Installation: 1. Remove the tail light housing from the vehicle. 2. Remove the tail light lens. 3. Remove the light bulb. 4. Remove the original bulb connector from the back side of the housing. 5. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended.
Page 2
7. Insert the new LED assembly into the hole where the original bulb and connector were located. Use caution when feeding the wires through the socket opening to avoid damaging the wire insulation. 8. Feed the wires through the large hole in the back plate. Guide the back plate onto the back side of the housing.
This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.