Dakota Digital LED Tail Lights for 1965 Nova LAT-NR130 Installation Instructions

Led tail lights for 1965 nova

Download this manual

MAN#650176

Kit Includes:

Installation:

1. Remove the tail light lens.

2. Remove the light bulb.

3. Remove the original bulb connector from the back side of the housing.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is

recommended.

5. Remove the screw and aluminum back plate from the new LED assembly.

INSTALLATION INSTRUCTIONS

LAT-NR130

LED Tail Lights for 1965 Nova

Page 1 MAN#650176 Kit Includes: Installation: 1. Remove the tail light lens. 2. Remove the light bulb. 3. Remove the original bulb connector from the back side of the housing. 4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended.
Page 2 6. Insert the new LED assembly through the hole where the original bulb and connector were. Use caution when feeding the wires through to avoid damaging the wire insulation. 7. Feed the wires through the large hole on the back plate. The flat side of the back plate should be toward the outside and the side with the slightly raised center should go in toward the housing.
Page 3: Service And Repair
This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.